Free tool
Encoder resolution calculator
Enter the line count, signal period or bit count: you get counts per revolution, angular or linear resolution, and the signal frequency at your speed.
How it is calculated
An incremental encoder gives one signal period per line on two tracks 90° apart. Evaluating all four edges of a TTL signal gives four counts per signal period. Sinusoidal 1 Vpp signals are interpolated in the following electronics, often much more finely.
The signal frequency is the frequency at the encoder output. It has to stay below the input frequency your control or counter card accepts and below the encoder’s own limit; both are in the data sheets.
Related
Frequently asked questions
Why multiply by 4 for a TTL encoder?
A TTL encoder outputs two square waves 90° apart. Counting every rising and falling edge of both gives four counts per signal period, so 2,500 lines give 10,000 counts per revolution.
What does interpolation mean for 1 Vpp encoders?
1 Vpp signals are sine waves. The control or interface electronics subdivides each signal period, often by hundreds or more, so the resolution depends on that electronics, not only on the encoder.
How do I get the resolution of an absolute encoder?
Positions per revolution are 2 to the power of the singleturn bits: a 25-bit encoder gives 33,554,432 positions, about 0.04 arc seconds each.
Why does the signal frequency matter?
Both the encoder and the control or counter card have a maximum frequency. If the line count × rpm ÷ 60 goes above it, counts are lost.